I hope that helps anyone should they encounter a similar issue, especially with HP computers.Ī word of warning: always make a disk image backup of your entire hard driveīefore you go changing around your partitions. System (Primary) | C Drive (Primary) | Sam's new partition (Primary, StillĬontains Factory Image, but now larger than previous) | HP Tools (Primary) Sam's hard drive layout then looked like this: Newly repurposed partition for whatever he wanted, and technically this did not break his pre-existing partition schema. Immediately next to it, and then marked all the files on the Factory Image drive as hidden. What I did was use MiniTool Paritition Wizard to merge the Unallocated space (which was originally taken from the C drive) with the Factory Image System (Primary) | C Drive (Primary) | Unallocated Space | Factory Image (Primary, In Sam's case, the hard drive layout looked like this: Recoveries doesn't work when you need it the most.Ī better way to go about this problem is to work with what is already there. Recovery - and you would not want to find out that either one of these In Sam's case, the Recovery and HP Tools were both primary changingĮither one to logical may break either the factory image restoration or the BIOS Going this route, because it will likely break the functionality of the computerĭown the road. Thus abiding by the laws of the master boot record (MBR). How to Fix: Cannot Create Partition: No Free MBR SlotsĪfter a bit more research I discovered that it is technically possible to convert one of the primary partitions into a logical partition, However, Sam's computer was from HP and they do things a little differently. With that said, most people won't run into this issue because most standard Windows installations will only contain 1 primary partition, which is located on the C drive. This information is then stored in the MBR (master boot Primary - which happens to be the maximum number of primary partitions you areĪllowed per disk. I did a bit of research, and what it boils down to is this: Sam had 4 partitions, and all of them were set as Partition Wizard and was also greeted with the same error Sam received earlier. Here's what I found:įirst, I launched Disk Management within Windows and right clicked over top of the unallocated space Sam had created earlier, but received an error stating that: " You cannot create a new volume in this unallocated space because the disk already contains the maximum number of partitions." I then tried to do the same using MiniTool I asked Sam if he would like me to connect to his system and look at the issue in depth, and he agreed. I use MiniTool Partition Wizard from time to time - it's good, and it's free - but, I have to say that I have never heard of this issue before. New volume, however, I receive an error message that says: 'Partition Wizard cannot create a partition here because there are no free MBR slots'. Normally I can right click the unallocated space and create a Used MiniTool Partition Wizard to shrink my C drive, which then created I have an HP computer, which has 4 hard drive partitions: the System partition, the C drive, theįactory image partition (which includes a backup of Windows), and the 'HP Tools' partition, which contains BIOS information in case a BIOS flash fails and I need to restore my BIOS.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |